Palmer PEBUFF Buffer/Booster Effects Pedal – Preamp for electrical Instruments
Palmer PEBUFF Buffer/Booster Effects Pedal for electrical instruments, electric guitars, bass guitars and keyboards.
Amplifying the electrical instruments signal before it goes to the input of a tube amplifier opens a whole world of new sounds.
The device can also be used as a cable driver for longer distances or larger pedalboard setups.
- Dimensions (L x W x H): 120 x 100 x 61 mm
- Voltage range: 9-20 V AC or DC, 9 V PP3 battery
- Max.power take-up: 10 mA
- Frequency response: 20 Hz – 10 kHz
- Distortion: 0.5% (1 kHz)
- Impedance, Input Normal: 1 MOhm
- Impedance, Input Bright: 4 MOhm
- Impedance, Output: 150 Ohm
- Signal-to-noise ratio: -60 dB
- Max. level: 5 V
- Max. gain: 13 dB
Palmer PEBUFF Buffer/Booster Effects Pedall that should be an essential on every pedal board, whether to keep your original guitar tone intact or to boost the signal. So what’s different about this buffer and the buffer you’d find on mass produced pedals? Well, the primary role of a buffer on a mass produced pedal is not to ‘rescue’ your guitar tone from degradation, but rather to drive the low quality transistor based switching system. The input impedance of these buffer circuits are thus designed not to keep all of the top end sparkle of your guitar tone.
Attention! This product is a discontinued line